Following directly from the success of the Studio Range is the 3300 Range. It is designed to operate a wide variety of processes including Glass and Ceramics and offers a host of new operator friendly features.

Each ramp is controllable either by rate per hour or by time taken to reach a set point. In rate per hour mode, the controller can be set down to as low as 1°c/hr, whilst in time taken to reach a set point mode it is possible to set even lower, kiln allowing of course.

A pause button allows the process to be held at any point and can be timed or held until the button is repressed. An information button can be pressed at any point during the firing, and will display items such as power used and controller set point.

3300/1:

• 1 Program
• 2 Segments, each segment has:-
  • 1 Ramp 1 Degree per hour to full on or “Time taken to reach temperature”
  • 1 Target temperature Centigrade or farenhiet
  • 1 Dwell. 0 – 99.59 Hours
  • 1 Dwell, 0 – 99.59 Hours

3300/2:

• As 3300/1 but with 10 Programs each having 4 segments

3300/3:

• As 3300/2 But with 16 segments per Program

3300/4:

• As 3300/3 But with Automatic Damper (event) Facility

3300/5:

• As 3300/4 But with 3 – Zone Control

3300 Controller Range - Features:

• Large red L.E.D. display showing kiln temperature and program segment number
• Use in degrees centigrade or Fahrenheit
• Set in degrees per hour or “ time to reach set point”
• Program pause button
• Segment forward button
• Power used indication
• 30 amp relay as standard
• On/Off switch
• Hidden lock button
• Wall mounting bracket
• Broken thermocouple protection
• Overfire alarm
• Power cut continue
• Button bleeper on adjusts
• For use with thermocouples K, N, R or S
• Made in Britain